| Model |
Units |
3000em |
| 470 |
| Injection |
 Screw diameter |
mm |
150 |
| Theoretical injection capacity |
cm3 |
13,200 |
| Injection mass |
Polystyrene (PS) |
g |
12,100 |
| Polyethylene (PE) |
9,770 |
| Maximum injection pressure |
MPa
(kgf/cm2) |
177 (1,800) |
| Maximum holding pressure |
147 (1,500) |
| Injection rate |
cm3/sec |
2,030 |
| Injection horsepower |
kW (PS) |
359 (488) |
| Plasticizing capacity (PP) |
kg/h |
1,000 |
| Screw RPM |
rpm |
167 |
| Nozzle touch force |
kN (tonf) |
98 (10.0) |
|
| Clamping |
Mold clamping force |
kN (tonf) |
29,420 (3,000) |
| Mold closing force |
1,824 (186) |
Mold opening / closing speed
(mold close / mold open) |
m/min |
50 |
| Mold board dimensions (H x V) |
mm |
3,200 x 2,500 |
| Tie bar space (H x V) |
2,050 x 1,900 |
| Clamping stroke, maximum |
2,700 |
| Daylight, maximum |
3,700 |
| Mold thickness |
1,000~1,900 |
| Ejector |
Injection force |
kN (tonf) |
392 (40) |
| Stroke |
mm |
350 |
| Speed (forward/reverse) |
m/min |
12.5 |
|
| General |
Heater capacity |
kW |
84.8 |
| Machine dimensions (L x W x H) |
m |
15.24 x 4.785 x 4.015 |
| Machine mass |
ton |
180 |
|
| * |
1. The numeric values in this table are subject to improvements or changes without notice.
2. Plasticizing capacity is based on standard test conditions performed by Mitsubishi.
3. Injection mass, injection ratio, and plasticizing capacity differ depending on the resin used and molding conditions.
Please contact us to discuss using the machine at the maximum capacity. |
|
